MIL-DTL-82114C(MC)
TABLE I.
Manufacturing requirements.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
1
Cutting.
a. Cut coat fronts in strict
accordance with patterns furnished.
b. Cut the material in the
directions indicated by directional
lines on pattern.
2
Replacement of damaged parts.
a. Replace at time of cutting any
part containing damages, such as
holes or seriously weakening defects,
such as smashes, multiple floats, and
slubs likely to develop into holes.
b. Replace any part damaged during
the manufacturing process by needle
chews which may be expected to
develop into a hole, scissors or
knife cuts, tears, holes, mends,
burns and large exposed drill holes.
Make coat fronts.
3
FSa-1
4-8
70/2
70/2
a. Abut or overlap (1/8 inch) the
304
edges of the shoulder and waist darts
or
on the front sections and stitch
LSa-1
together through the polyester/cotton
dart stay.
The abutted or overlapped edges may
be stitched together prior to
stitching through stay.
b. Abut or overlap (1/8 inch) the
304
FSa-1
4-8
70/2
70/2
edges of the shoulder and waist darts
or
on the chest piece and stitch
LSa-1
together.
c. Position the haircloth reinforce-
304
FSa-1
4-8
70/2
70/2
ment piece at the top front corner of
or
the coat front on the inner side of
LSa-1
the body sections. Place the chest
piece on top of the haircloth
reinforcement; place the padding and
the polyester/cotton covering for the
front edge on top of the chest piece.
Quilt all parts together with
vertical rows of stitching 3/8 to 3/4
inch apart, and with curved rows
toward the armhole, and the shoulder
portion shall be left open to
accommodate the shoulder pads.
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business