MIL-DTL-14656B (ARMY)
EXAMINE
DEFECT
CLASSIFICATION
CRITICAL
(T)
MINOR
Any significant detail marred, missing,
T
reduced, obliterated, or unclear ................
Any area not pierced as indicated by
drawing (Type II only) .............................
X
Any warp, twist, or distortion producing
irregular surface contour or outline ............
X
Not dapped as indicated by drawing or
specification .........................................
X
Construction &
Metal marks such as nicks, cracks,
T
Workmanship
dents, digs, gouges, or scratches ..............
Not trimmed to die-struck edge ..................
X
Die struck edge not well defined .................
X
T
Edge not die-struck ..................................
T
Pinhole, crack, or rupture ..........................
Any sharp or rough edge, burr, drag or
T
step, or tool marks .................................
Insignia not closely dapped to fit
contour of buckle (Type II only).................
X
Any component missing, bent, twisted,
broken, deformed, or otherwise
impaired ..............................................
X
Not pierced when/where required (Type II
only)....................................................
X
T
Piercing not clean & smooth (Type II only) ...
Piercing operation distorts insignia (Type II
only) ...................................................
X
Insignia out of alignment ...........................
X
Insignia not securely mounted on
the buckle (Type II only)...........................
X
Penetration of marking to opposite
surface, unevenness, or distortion .............
X
Soldering
Component parts not joined adequately by
soldering..............................................
X
Joints not clean and smooth, i.e., flux or
excess solder not removed ......................
X
Any area burned or reduced in
T
soldering or acid cleaning .......................
.
Not silver solder when required, i.e. wrong
type of solder.........................................
X
Marking
Missing, illegible, incorrect, or incomplete .....
X
T
Conspicuously placed ..............................
4.3.3.2 Examination of the buckle for defects in dimensions. Any dimension which is
not as given in the specification or the drawing shall be classified as "(T)."
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business